1995 Draining Hpop Rough Idle Sluggish Throttle Response 7.3L - DIESEL FORUM - ALL DIESEL FORUM
DIESEL FORUM - ALL DIESEL FORUM  

Go Back   DIESEL FORUM - ALL DIESEL FORUM > Ford Diesel Forum - Power Stroke Forum > POWER STROKE TECHNICAL ISSUES - TROUBLE SHOOTING > Other Ford Diesels > Powertrain Engine, Transmission & Differentials Ford Diesel Trucks
Notices

Powertrain Engine, Transmission & Differentials Ford Diesel Trucks Ford Diesel Mechanical Problems and Questions.

Reply
 
Thread Tools
  #1  
Old 05-21-2017, 01:59 PM
xyxyxyz xyxyxyz is offline
Diesel Forum Newcomer
 
Join Date: May 2017
Posts: 1
Gender: Male
Vehicle: Ford
Trim Level: XLT
Color: Black
Engine: 1994.5 - 1996/97 444ci (7.3L) DI Power Stroke (275hp 550Tq) Manual
Rep Power: 0
Rep:10
xyxyxyz is on a distinguished road
Default 1995 Draining Hpop Rough Idle Sluggish Throttle Response 7.3L

Traded one of my trucks for 7.3, when i got it i found out after the trade that he must have been starting it with ether. First i put diesel clean injector cleaner in it along with lucas oil additive full synthetic. Afterwards i went ahead and put new glo-plugs injector o rings and a valve cover harness on the passenger side. This is my first time putting my hands on a diesel and got it as a learning experience. I found out i had put my o rings on wrong and had to take it back apart and put new ones on again. In this process (first putting in the injectors with the bad o ring setup) my dumbass thought it was ok to beat on the tops of the injectors to get them in far enough to get the screw in. Anyways i got that job all put back together and it still wouldnt start. Went to the hpop plug and the reservoir was bone dry. I filled the hpop through the plug and the truck started after a little bit of cranking. Although the idle of the truck was horrible and the throttle response was very sluggish like it had no power. Most times it would run until the hpop drained and then it would shut off. Also replaced starter solenoid and glow plug relay. The IPR where the magnetic piece goes on the shaft of it was slightly bent so i have a new IPR coming and ICP. Also did the whole unplug the ICP and see if it runs and there was no difference. Today i tested the valve cover harness resistances. On each 5 pin at the gasket the outside pins both read under 2 ohms on each connector but the rest of the pins read OL. Wondering if anyone had any recommendations not very experienced with diesel mechanics and dont wanna keep throwing money in the wrong directions.Thanks!
__________________
DieselForums.com | Diesel Forum | Diesel Forums | Cummins Diesel | Duramax Diesel | Power Stroke Diesel
Reply With Quote Quick reply to this message
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the DIESEL FORUM - ALL DIESEL FORUM forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address

Please enter a valid email address for yourself.

Note: If your email address requires someone to click a link before they can send you email, DO NOT REGISTER WITH IT as no one is here to click the link and you will never get your activation email!
We have banned MANY Free email providers.
If you get notice that your email address is banned when you try to sign up, it is because its been banned due to spammers using the provider, or too many members bouncing emails we send back to us via the free provider! If this happens to you, you will need to use a different email. If you do not provide a valid email address you will not receive your activation email. We recommend that you register with an email address which is attached to your ISP! Not a free service! We have found that using free accounts causes you to not receive your registration email. In any case, you should add DieselForums.com to your spam filter whether using a free account or your ISP account. If you bounce email to us, you will have your account deleted and your IP address banned!

Email Address:
Select your Sex!
"LOTS" IS NOT AN OPTION!
Vehicle Make
Choose your make!
Trim Level
What trim level did you purchase?
Insurance
Please select your insurance company (Optional)
Color?
What color is your vehicle?
Engine?
Please select your engine so that members will be better able to answer questions you ask on the forum! This shows up on your profile page, and posts! SOMETHING MISSING? LET US KNOW!
Date of Birth
Your date of birth and age are displayed in several places on the forum. Only the administrator will have access to your date of birth should you choose to hide it via the privacy option below.
Month Day Year
     
Privacy

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Advertisement



All times are GMT -4. The time now is 08:29 AM.


Powered by vBulletin® Version 3.8.10 Beta 2
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright DieselForums.com a VerticalScope.com Network Site =